Advertisement
BEFORE YOU BEGIN
Thank you for selecting the PROFORM
405S tread-
®
mill. The PROFORM
®
405S treadmill combines
advanced technology with innovative design to let you
enjoy an excellent form of cardiovascular exercise in
the convenience and privacy of your home. And when
you're not exercising, the unique PROFORM
®
405S
can be folded up, requiring less than half the floor
space of other treadmills.
For your benefit, read this manual carefully before
using the treadmill. If you have additional questions,
Speed Control
Accessory Tray
Handrails
Storage Latch
Walking Belt
Foot Rails
BACK
Rear Roller
Adjustment Bolts
please call our Customer Service Department at
08457 089 009. To help us assist you, please note the
product model number and serial number before call-
ing. The model number of the treadmill is PETL40510.
The serial number can be found on a decal attached
to the treadmill (see the front cover of this manual for
the location).
Before reading further, please review the drawing
below and familiarise yourself with the parts that are
labelled.
Water Bottle Holder
(Bottle not included)
Console
Key/Clip
FRONT
Circuit
Breaker
RIGHT SIDE
Incline Leg
4
PROBLEM: The walking belt slows when walked on
SOLUTION: a. If an extension cord is needed, use only a 3-conductor, 1mm
than 1.5 m (5 ft.).
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the allen wrench, turn
both rear roller adjustment bolts counterclockwise, 1/4
of a turn. When the walking belt is properly tightened,
you should be able to lift each side of the walking belt
7–10 cm (3–4 in.) off the walking platform. Be careful
to keep the walking belt centred. Plug in the power
cord, insert the key and run the treadmill for a few
minutes. Repeat until the walking belt is properly tight-
ened.
c. If the walking belt still slows when walked on, please call our Customer Service Department.
PROBLEM: The walking belt is off-centre or slips when walked on
SOLUTION: a. If the walking belt has shifted to the left, first
remove the key and UNPLUG THE POWER CORD.
Using the allen wrench, turn the left rear roller bolt
clockwise 1/2 of a turn. Be careful not to overtighten
the walking belt. If the walking belt has shifted to
the right, turn the left rear roller bolt counterclock-
wise 1/2 of a turn. Plug in the power cord, insert the
key and run the treadmill for a few minutes. Repeat
until the walking belt is centered.
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
the allen wrench, turn both rear roller adjustment
bolts clockwise, 1/4 of a turn. When the walking belt
is correctly tightened, you should be able to lift each
side of the walking belt 7–10 cm (3–4 in.) off the
walking platform. Be careful to keep the walking belt
centred. Plug in the power cord, insert the key and
carefully walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
2
(14-gauge) cord that is no longer
b
7–10 cm
Rear Roller Adjustment Bolts
a
b
13
Advertisement
