Command Alarm - Panasonic WJ-ND400K Setup Instructions

Command alarm

Configure the settings relating to event actions to be taken at a command alarm occurrence.
1
Click the [Event] button.
2
Click the [Command alarm] tab.
The "Command alarm" page will be displayed.
Setup items
■ Rec. cam.
Select a camera channel (Cam.1 - Cam.64, "--") used
for recording. When no camera channel is selected
("--"), recording will not be performed.
■ Preset position
Enter a preset position (blank, 1-256) to which the cam-
era will move at an alarm occurrence.
When no position is entered (blank), the camera does
not move to any preset position.
Default: blank
42
3
Configure each setting item.
Refer to "Setup items" mentioned below.
To display the setting page of the command alarm
whose command number is not on the current
page, click the desired command number range dis-
played above the [Set] button.
When displaying other setting page of the command
by clicking the command number range above the
[Set] button, the settings edited on the currently dis-
played setting page will be saved and applied.
4
Click the [Set] button.
■ Output terminal
Select "On" or "Off" to determine whether or not to out-
put an alarm signal at an event occurrence.
Default: On