3.
Push the power trim and tilt switch "
(down) to lower the outboard motor to
the desired position.
UP
DN
DN
EMU28063
Shallow water
EMU28074
Cruising in shallow water (manual tilt
models)
EWM01782
WARNING
Run the boat at the lowest possible
speed when using the shallow water
cruising system. The tilt lock mecha-
nism does not work while the shallow
water cruising system is being used.
Hitting an underwater obstacle could
cause the outboard motor to lift out of
the water, resulting in loss of control.
Use extra care when operating in re-
verse. Too much reverse thrust can
ZMU06545
cause the outboard motor to lift out of
the water, increasing the chance of ac-
"
cident and personal injury.
ECM00261
NOTICE
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
ZMU01936
DN
EMU28126
Procedure
ZMU06546
1.
Place the remote control lever / gear
shift lever in neutral.
Operation
53