Table of Contents
Advertisement
EMU33121
Procedure for tilting down (power
trim and tilt models)
1.
Push the power trim and tilt switch "
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support lever
becomes free.
2.
Release the tilt support lever.
3.
Push the power trim and tilt switch "
(down) to lower the outboard motor to
the desired position.
UP
DN
DN
"
ZMU03998
"
ZMU01936
DN
ZMU03999
EMU28062
Shallow water
EMU32851
Power trim and tilt models
The outboard motor can be tilted up partially
to allow operation in shallow water.
ECM00260
NOTICE
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32922
Procedure for power trim and tilt models
1.
Place the remote control lever in neutral.
2.
Slightly tilt the outboard motor up to the
desired position using the power trim
and tilt switch. WARNING! Using the
power trim and tilt switch on the bot-
tom cowling while the boat is moving
or engine is on could increase the
risk of falling overboard and could
distract the operator, increasing the
risk of collision with another boat or
an obstacle.
[EWM01850]
Operation
59
Advertisement
Table of Contents
