Installation Requirements; Boat Horsepower Rating; Mounting Motor; Remote Control Requirements - Yamaha F25D Owner's Manual

Specifications and requirements
F25DMH 0.320 L (0.338 US qt, 0.282
Imp.qt)
FT25FET 0.430 L (0.455 US qt, 0.378
Imp.qt)
Tightening torque:
Spark plug:
17 Nm (1.73 kgf-m, 12.5 ft-lb)
Propeller nut:
34 Nm (3.47 kgf-m, 25.1 ft-lb)
Engine oil drain bolt:
27 Nm (2.75 kgf-m, 19.9 ft-lb)
Engine oil filter:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
Noise and vibration level:
Operator sound pressure level (ICOMIA
39/94):
84.2 dB(A)
Vibration on tiller handle (ICOMIA 38/94):
F25DMH Vibration on tiller handle is
under 2.5 m/s
EMU33555

Installation requirements

EMU33565

Boat horsepower rating

EWM01561
WARNING
Overpowering a boat can cause severe
instability.
Before installing the outboard motor(s), con-
firm that the total horsepower of your out-
board motor(s) does not exceed the boats
maximum horsepower rating. See the boat's
capacity plate or contact the manufacturer.
EMU33572

Mounting motor

EWM01571
WARNING
Improper mounting of the outboard mo-

tor could result in hazardous condi-
tions such as poor handling, loss of
control, or fire hazards.
12
2
Because the motor is very heavy, spe-

cial equipment and training is required
to mount it safely.
Your dealer or other person experienced in
proper rigging should mount the motor using
correct equipment and complete rigging in-
structions. For further information, see page
31.
EMU33582

Remote control requirements

EWM01581
WARNING
If the engine starts in gear, the boat can

move suddenly and unexpectedly, pos-
sibly causing a collision or throwing
passengers overboard.
If the engine ever starts in gear, the

start-in-gear protection device is not
working correctly and you should dis-
continue using the outboard. Contact
your Yamaha dealer.
The remote control unit must be equipped
with a start-in-gear protection device(s). This
device prevents the engine from starting un-
less it is in neutral.
EMU25695

Battery requirements

EMU25723

Battery specifications

Cold cranking amps (CCA/EN):
F20DET 347–411 A
F25DE 347–411 A
F25DET 347–411 A
FT25FET 347–411 A
Min. rated capacity (20HR/IEC):
F20DET 40 Ah
F25DE 40 Ah
F25DET 40 Ah
FT25FET 40 Ah
The engine cannot be started if battery volt-
age is too low.