Sidestand - Yamaha XMAX 250 YP250R Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
s WARNING
s
Always adjust both shock absorber
assemblies equally, otherwise poor
handling and loss of stability may
result.
Adjust the spring preload as follows.
3
1. Adjusting ring
2. Position indicator
To increase the spring preload and
thereby harden the suspension, turn
the adjusting ring on each shock
absorber assembly in direction (a). To
decrease the spring preload and the-
reby soften the suspension, turn the
adjusting ring on each shock absor-
ber assembly in direction (b).
EWA10210 NOTE:
Align the appropriate notch in the
adjusting ring with the position indica-
tor on the shock absorber.
Spring preload setting:
Minimum (soft):
1
Standard:
1
Maximum (hard):
4

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the motorcycle upright.
1
1. Sidestand switch
2. Sidestand
NOTE:
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain
situations. (See further down for an
explanation of the ignition circuit cut-
off system.)
s WARNING
s
The vehicle must not be ridden with
the sidestand down, or if the sides-
EAU15301
tand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control. Yama-
ha's ignition circuit cut-off system
has been designed to assist the
operator in fulfilling the responsibi-
lity of raising the sidestand before
starting off. Therefore, check this
system regularly as described
below and have a Yamaha dealer
repair it if it does not function pro-
perly.
2
3-12
EWA10240