Engine Oil - Yamaha XMAX 250 YP250R Owner's Manual

Table of Contents

Advertisement

PERIODIC MAINTENANCE AND MINOR REPAIR
NOTE:
Make sure the spark plug wire is fas-
tened in the clamp as shown.
5. Install the storage compartment
by installing the bolts.
6. Close the seat.

Engine oil

The engine oil level should be chec-
ked before each ride. In addition, the
oil must be changed at the intervals
specified in the periodic maintenance
and lubrication chart and when the
service indicator light comes on.
6
To check the engine oil level
1. Place the scooter on the centers-
tand.
NOTE:
Make sure that the scooter is positio-
ned straight up when checking the oil
level. A slight tilt to the side can result
in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
EAUM1550
1. Dipstick
2. Max-min marks
3. Oil filler cap
3. Wait a few minutes until the oil
settles, remove the oil filler cap,
wipe the dipstick clean, insert it
back into the oil filler hole (wit-
hout screwing it in), and then
remove it again to check the oil
level.
NOTE:
The engine oil should be between the
minimum and maximum level marks.
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to rai-
se it to the correct level.
5. Insert the dipstick into the oil filler
To change the engine oil
1. Start the engine, warm it up for
2. Place an oil pan under the engine
1. Oil drain bolt
3. Remove the engine oil filler cap
4. Check the washer for damage
5. Install the washer and the engine
6-7
hole, and then tighten the oil filler
cap.
several minutes, and then turn it
off.
to collect the used oil.
and the engine oil drain bolt to
drain the oil from the crankcase.
and replace it if necessary.
oil drain bolt, and then tighten the
drain bolt to the specified torque.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents