Replacing A Headlight Bulb - Yamaha XMAX 250 YP250R Owner's Manual

3. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.

Replacing a headlight bulb

This model is equipped with quartz
bulb headlights. If a headlight bulb
burns out, replace it as follows.
1. Remove cowling B. (See page
6-5.)
1
1. Headlight coupler
PERIODIC MAINTENANCE AND MINOR REPAIR
2. Disconnect the headlight coupler,
and then remove the headlight
bulb cover.
3. Remove the headlight bulb hol-
der according to the following
illustration, and then remove the
defective bulb.
EAU23910
1. Headlight bulb cover
NOTE:
The removal procedure depends on
1 the type of bulb holder installed on
your vehicle.
s WARNING
s
Headlight bulbs get very hot. The-
refore, keep flammable products
away from a lit headlight bulb, and
do not touch the bulb until it has
cooled down.
4. Place a new bulb into position,
1
CAUTION
Do not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency of
the glass, the luminosity of the
bulb, and the bulb life will be adver-
sely affected. Thoroughly clean off
6-20
and then secure it with the bulb
holder.
EWA10790
6
ECA10660