Yamaha diversion 900 XJ900S Owner's Manual page 79

CAUTION:
_
Do not push the brake pedal after
the wheel has been removed togeth-
er with the brake disc, otherwise the
brake pads will be forced shut.
_
PERIODIC MAINTENANCE AND MINOR REPAIR
ECA00062
1. Splines
To install the rear wheel
1. Apply a light coating of lithium-
soap-based grease to the splines
of the final gear case and wheel
hub.
2. Install the wheel, brake caliper
bracket, spacer and wheel axle.
3. Install the brake caliper by install-
ing the bolts.
NOTE:
_
Make sure that there is enough space
between the brake pads before install-
ing the brake caliper onto the brake
disc.
_
4. Connect the brake torque rod to
5. Install the axle nut, and then slight-
6. Take the motorcycle off the cen-
7. Tighten the rear wheel axle pinch
EAU04362
6-36
the brake caliper bracket by in-
stalling the bolt and the nut.
ly tighten it.
terstand so that the rear wheel is
on the ground.
bolt, the axle nut, the brake caliper
bolts and the brake torque rod nut
to the specified torques.
Tightening torques:
Axle nut:
105 Nm (10.5 m·kgf)
Brake caliper bolt:
40 Nm (4.0 m·kgf)
Brake torque rod nut:
23 Nm (2.3 m·kgf)
Rear wheel axle pinch bolt:
16 Nm (1.6 m·kgf)
6