Throttle Lever - Yamaha BLASTER YFS200W Owner's Manual

EBU18070
Engine stop switch "ENG. STOP"
Set this switch to "RUN" before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to "OFF".
EBU18110
Light switch "LIGHTS"
Set this switch to "LO" to turn on the low beam and
the taillight. Set the switch to "HI" to turn on the
high beam and the taillight. Set the switch to "OFF"
to turn off all the lights.
NOTE:
The headlight and the taillight can be turned on
only when the engine is running.
EBU18280

Throttle lever

Once the engine is running, movement of the throt-
tle lever will increase the engine speed.
Regulate the speed of the ATV by varying the
throttle position. Because the throttle is spring-
loaded, the ATV will decelerate, and the engine will
return to an idle any time the hand is removed from
the throttle lever.
1. Throttle lever
Before starting the engine, check the throttle to be
sure it is operating smoothly. Make sure it returns
to the idle position as soon as the lever is released.
EWB00250
WARNING
Malfunction of the throttle could make it diffi-
cult to speed up or slow down when you need
to. This could cause an accident. Check the op-
eration of the throttle lever before you start the
engine. If the throttle does not work smoothly,
check for the cause. Correct the problem be-
4-3
1
1
2
3
4
5
6
7
8
9
10
11