Brake Light Switches; Adjusting The Clutch Lever Free Play - Yamaha BLASTER YFS200W Owner's Manual

EWB02090
WARNING
1
Operating with improperly serviced or adjust-
ed brakes could cause the brakes to malfunc-
2
tion, resulting
performance. This could increase the chance
3
of a collision or accident. After adjusting the
parking brake free play, block the rear of the
4
ATV off the ground and spin the rear wheels.
Check to make sure there is no brake drag. If
5
brake drag is noticed, perform the adjustment
again.
6
7
EBU24740

Brake light switches

8
The operation of the brake light switches must be
checked and, if necessary, adjusted at the inter-
9
vals specified in the periodic maintenance and lu-
brication chart.
10
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
11
switches should be adjusted by a Yamaha dealer.
NOTE:
The brake light switch is properly adjusted when
the brake light comes on just before braking takes
in reduced braking
effect.
Turn the adjusting nut while holding the brake light
switch in place. To make the brake light come on
earlier, turn the adjusting nut in direction (a). To
make the brake light come on later, turn the adjust-
ing nut in direction (b).
1
(b)
1. Brake light switch
2. Brake light switch adjusting nut
EBU24810

Adjusting the clutch lever free play

The clutch lever free play must be checked and, if
necessary, adjusted at the intervals specified in
the periodic maintenance and lubrication chart.
The clutch lever free play should measure 2.0–3.0
8-29
(a)
2