Yamaha BLASTER YFS200W Owner's Manual page 103

3. Loosen the locknut and the adjusting bolt at
the rear brake caliper.
4. Turn the adjusting bolt at the clutch lever in di-
rection (a) to increase the cable length, and in
direction (b) to decrease it.
1. Locknut
2. Adjusting bolt
NOTE:
If the cable length cannot be adjusted to specifica-
tion, consult a Yamaha dealer.
5. Tighten the locknut at the clutch lever.
6. Turn in the adjusting bolt at the rear brake cal-
iper by hand until it feels tight, then turn it out
1 2
(a)
(b)
1. Adjusting bolt
2. Locknut
Tightening torque:
ECB00520
CAUTION:
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that it does not turn
together with the locknut.
8-28
1/8 turn and tighten its locknut to the specified
torque.
1
2
Locknut (rear brake caliper):
16 Nm (1.6 m·kgf, 11 ft·lbf)
1
2
3
4
5
6
7
8
9
10
11