Setting Operating Mode; Setting Room Values; Adjusting Curve Values; Adjusting A Specific Part Of The Heat Curve - York Geysir User Manual

5 .1

Setting operating mode

In the control computer you can choose between five operating modes:
To change the operating mode:
1. Press either the right or left button once to open the INFORMATION main menu. The
cursor is in the OPERATION menu option.
2. Open your selection by pressing the right button once. An asterisk indicates the current
operating mode.
3. Mark the new desired operating mode using the up or down button.
4. Press the right button once to confirm your choice. The asterisk moves to your selected
operating mode.
5. Press the left button twice to exit the menu.
5 .2

Setting ROOM values

If the indoor temperature is too high or too low, you can adjust the ROOM value to change
the indoor temperature.
To change the ROOM value:
1. Press either the up or the down button once to open and change the ROOM value.
2. Raise or reduce the ROOM value using the up or down buttons to change the indoor
temperature.
3. Wait ten seconds or press the left button once to exit the menu.
5 .3

Adjusting CURVE values

To change the CURVE value:
1. Press either the right or left button once to open the INFORMATION main menu. The
cursor is in the OPERATION menu option.
2. Press the down button to move the cursor to the HEATCURVE menu option.
3. Open the menu by pressing the right button once. The cursor is at CURVE.
4. Open your selection by pressing the right button once.
5. Raise or reduce the value with the up or down buttons. The graph shows how the curve
slope changes.
6. Press the left button three times to exit the menu.
5 .4

Adjusting a specific part of the heat curve

To change a specified part of the heat curve:
1. Press either the right or left button once to open the INFORMATION main menu. The
cursor is in the OPERATION menu option.
2. Press the down button to move the cursor to the HEATCURVE menu option.
3. Open the menu by pressing the right button once. The cursor is at the CURVE value.
4. Select CURVE 5, CURVE 0 or CURVE -5 using the up or down buttons.
5. Open your selection by pressing the right button once.
6. Raise or reduce the value with the up or down buttons.
7. Press the left button three times to exit the menu.
EN
33
ENGLISH