Garmin GTX330 Installation Manual page 58

Using the FUNC and/or START/STOP keys, toggle through the pages to get off of, then back onto the
aircraft address page. Verify that the address is correct.
Turn the unit off. Power the unit back on in the normal mode. If the FLIGHT ID PWR-UP ENTRY page
was selected verify that the unit requests the correct page during system turn on.
An important factor to consider while configuring the GTX 330 is this:
POWER UP ENTRY requires that a variable Mode S FLIGHT
ID is entered each time the unit is powered on. The selections
SAME AS TAIL and CONFIG ENTRY are fixed entries. The
two fixed selections do not require any transponder interaction
from the flight crew, whereas POWER UP ENTRY always does.
If POWER UP ENTRY is selected an initial Flight ID must be entered as a default. To
set the default Flight ID, select POWER UP ENTRY and enter the tail number or
"UNKNOWN" for the Flight ID.
Page 5-18
Revision R
NOTE
GTX 330/GTX 330D Installation Manual
PWR-UP CONFIG ENTRY Page
PWR-UP SAME AS TAIL Page
190-00207-02