Yamaha FJR1300A Owner's Manual page 28

Instrument and control functions
 The tripmeters will reset and con-
tinue counting after 9999.9 is
reached.
When approximately 5.5 L (1.45 US
gal, 1.21 Imp.gal) of fuel remains in the
fuel tank, the last segment of the fuel
meter starts flashing. In addition, the
information display will automatically
change to the fuel reserve tripmeter
3 mode "TRIP-F" and start counting the
distance traveled from that point.
GEAR
TRIP-F
In this case, push the select switch to
switch the display in the following or-
der:
TRIP-F → Display–1 → Display–2 →
Display–3 → TRIP-F
To reset a tripmeter, use the select
switch to select the information display
that contains the tripmeter you want to
reset. Push the "RESET" button briefly
so that the tripmeter flashes, and then
push the "RESET" button again for 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally after refueling and traveling 5 km
(3 mi).
4
km
3.4
Estimated traveling range display:
RANGE
The distance that can be traveled with
the remaining fuel in the fuel tank under
the current riding conditions is shown.
Elapsed time display:
TIME TRIP
The time that has elapsed since the key
was turned to "ON" is shown. The
maximum time that can be shown is
99:59.
This timer automatically resets when
the key is turned to "OFF".
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
"Setting mode" on page 3-16 for de-
tailed information.
Ambient temperature display:
A.TEMP
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
3-14
km
11
0:06
˚C
25