Yamaha FJR1300A Owner's Manual page 20

Instrument and control functions
Try to reset the traction control system
and the lights by following the proce-
dures under "Resetting" on page 3-28.
Immobilizer system indicator
light " "
When the key is turned to "OFF" and
30 seconds have passed, the indicator
light will flash steadily to indicate the
3
immobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
The electrical circuit of the indicator
light can be checked by turning the key
to "ON". The indicator light should
come on for a few seconds, and then
go off.
If the indicator light does not come on
initially when the key is turned to "ON",
if the indicator light remains on, or if the
indicator light flashes in a pattern (if a
problem is detected in the immobilizer
system, the immobilizer system indica-
tor light will flash in a pattern), have a
Yamaha dealer check the vehicle.
TIP
If the immobilizer system indicator light
flashes in the pattern, slowly 5 times
then quickly 2 times, this could be
caused by transponder interference. If
this occurs, try the following.
1. Make sure there are no other im-
mobilizer keys close to the main
switch. Other immobilizer system
keys may cause signal interfer-
ence and prevent the engine from
starting.
2. Use the code re-registering key to
start the engine.
3. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
4. If one or both of the standard keys
do not start the engine, take the
EAU73120
vehicle and all 3 keys to a Yamaha
dealer to have the standard keys
re-registered.
3-6