Weider WEEVSY49220 User Manual page 8

5. Press four 40mm x 60mm Inner Caps (27) into
the ends of the Top Frame (55).
6. Hold the Top Frame (55) on top of the Front
Upright (42) between the Weight Guides (62).
Attach the Top Frame to the Front Upright with
two M10 x 60mm Bolts (7), the Support Plate
(71), and two M10 Nylon Locknuts (21).
Attach the Weight Guides (62) to the Top Frame
(55) with the M10 x 155mm Bolt (60), two 15mm
Spacers (61), two M10 Washers (9), and an M10
Nylon Locknut (21).
Tighten the M10 Nylon Locknuts (21) used in
steps 1 through 3 and step 6.
Arm Assembly
7. Lubricate the M10 x 92mm Bolt (16). Attach the
Press Frame (17) to the Base (4) with the Bolt
and an M10 Nylon Locknut (21). Do not over-
tighten the Nylon Locknut; the Press Frame
must be able to pivot easily.
8. Press a 50mm Square Inner Cap (44) into the top
of a Press Arm (46). Attach the Press Arm to the
Press Frame (17) with two M10 x 70mm Bolts
(22) and two M10 Nylon Locknuts (21).
Repeat this step with the other Press Arm (46).
5
27
55
27
27
27
6
7
61
55
60
9
9
21
42
62
21
21
7
17
16
Lubricate
4
21
8
44
46
46
21
22
17
8
ATTACHING THE SEAT FRAME
To attach the Seat Frame (36) to the Front Upright
(42), slide one of the three slots in the bracket on the
Seat Frame onto the pin on the Front Upright. Note:
The Seat Frame can be adjusted to three heights
using the different slots in the bracket. Secure the
Seat Frame to the Upright with the M10 x 80mm
Carriage Bolt (11) and the Seat Knob (49).
For some exercises, the Seat Frame (36) must be
removed. First, be sure that the chain is not attached
to the leg lever. Next, remove the Seat Knob (49) and
the M10 x 80mm Carriage Bolt (11) from the Seat
Frame. Lift the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
CABLE
To use the Leg Lever (29), the seat frame must be
attached to the front upright (see ATTACHING THE
SEAT FRAME above).
Attach one end of the Chain (52) to the end of the
Low Cable (69) by the Front Upright (42) with a Cable
Clip (53). Attach the other end of the Chain to the
bracket on the back of the Leg Lever (29) with anoth-
er Cable Clip.
ATTACHING THE CURL PAD
To attach the Curl Pad (24) to the weight system, the
seat frame must be attached to the front upright (see
ATTACHING THE SEAT FRAME above). Remove the
38mm Square Inner Cap (32) from the Seat Frame
(36). Insert the Curl Post (35) into the Seat Frame and
secure it with the Curl Knob (51).
Always remove the Curl Pad (24) when it is not in use,
and replace the 38mm Square Inner Cap (32).
49
Slot
11
36
Pin
42
29
53
52
42
69
51
32
35
24
36
17