Installing The Castor Wheels; Installing The Carrier Frame To The Traction Unit - Toro 30149 Operator's Manual

Installing the Castor Wheels

1. Place the 2 thrust washers and spacer onto the castor
wheel fork (Fig. 2).
1
3
4
5
Figure 2
1. Locking pIn
2. Thrust washer (4)
3. Carrier frame mounting
tube
2. Insert the castor wheel fork into the carrier frame
mounting tube (Fig. 2).
3. Install 2 thrust washers onto the castor wheel fork.
4. Secure the assembly with a locking pin (Fig. 2).
5. Set the castor wheel tire pressure to 12–15 psi
(83–103 kPa).
2
2
4. Spacer
5. Castor wheel fork
Installing the Carrier Frame to
the Traction Unit
1. Align the carrier frame holes with the mounting holes in
the traction unit frame (Fig. 3).
2
1
Figure 3
1. Carrier frame
2. Fasten each side of the carrier frame to the traction unit
with 3 flange screws (1/2 x 1 in) and locknuts.
Note: Torque the mounting screws to 60–80 ft-lb
(81–109 N m) (Fig. 3).
5
2. Traction unit frame