Table of Contents
Advertisement
Implement Lift Lever
The implement lift lever (Fig. 6) is used to raise and
lower various attachments.
Raising Attachments
1.
Remove pressure from traction pedal to stop the
machine.
2.
Pull implement lift lever (Fig. 6) rearward to
raise attachment to the desired height.
Lowering Attachments
1.
Remove pressure from traction pedal to stop the
machine.
2.
Push implement lift lever (Fig. 6) forward to
lower attachment.
Note:
Hold lift lever in down position 1–2
seconds after attachment in down to
extend lift cylinder allowing
attachment to float with changes in
ground contour.
Figure 6
1. Lift lever
2. Lift–raise
3. Lift–lower
Adjusting Gage Wheels
The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1.
After adjusting height-of-cut. raise the
attachment lift lever: Refer to Raising
Attachments.
2.
Remove hairpin cotter and pin to change hole
location (Fig. 7).
3.
Select a hole position so the gage wheel is 3/8"
(9.5 mm) off the ground for the height-of-cut to
be used (Fig. 7).
4.
Insert pin and secure with hairpin cotter.
5.
Repeat adjustment on other gage wheels.
3
1
Figure 7
1. Wheel
2. Pin
Operation
2
m–3197
3. Hair pin cotter
7
Advertisement
Table of Contents
