Identification With The Chip Card; Deactivating Identification At The Other Telephone - Siemens HOPATH 4000 Operating Instructions Manual

Step by Step
Chip card
reader:
Insert chip
card
D
Enter the code!
program/service
PIN / COS?
Deactivate PIN?
Chip card
reader:
Insert chip
card
Using a different telephone in the same way as your own

Identification with the chip card

Precondition: You have been assigned a chip card by
your service personnel for logon at other telephones.
The optiPoint 500 at which you wish to log on must be
equipped with a chip card reader (optiPoint 500 signa-
ture module).
Within your own HiPath 4000 or Hicom 300 E/H (not
used in US) system:
Insert the chip card. All lamps light up briefly.
"ID card" and the number of the home station are indi-
cated on the display.
or At another HiPath 4000 or Hicom 300 E/H (not used
in US) system in the integrated network:
Insert the chip card.
Enter the node code for your own HiPath 4000 or
Hicom 300 E/H (not used in US) system (check with
your service personnel).
DG
Enter your own number and press the pound key.
Deactivating identification at the other
telephone
If you logged on with a PIN:
Press the key. The lamp lights up.
??
Enter the service code.
or
Select and confirm.
Select and confirm.
Identification is deactivated automatically if the
other telephone is not used for several minutes.
If you logged on with a chip card:
Remove the chip card when the telephone is in the idle
state.
89 89 89 89