Fireplace Installation Instructions - Empire Comfort Systems OP36FP32MN-3 Installation Instructions And Owner's Manual

FIREPLACE INSTALLATION INSTRUCTIONS

BOTTOM OF
FIREPLACE
OPENING
FOR A RAISED HEARTH:
COVER ANY COMBUSTIBLE
MATERIALS WITH
NON-COMBUSTIBLE
MATERIAL THE WIDTH
OF THE FIREPLACE
OPENING AND EXTENDING
AT LEAST 16 INCHES FROM
THE FIREPLACE
COMBUSTIBLE MATERIALS
HEARTH PLATFORM
NOTICE: Hearth is not required if fireplace is installed on finished
floor.
Fireplace Framing
Fireplace framing can be built before or after the fireplace is set
in place. The fireplace framing should be constructed of metal
studs or 2 x 4 lumber or heavier. The framing top plate or header
may be as close as 3/4 inch to the top of the fireplace. Refer to
Figure 14 for fireplace framing dimensions.
Premium Fireplace Framing Dimensions
Model A
OP36FP 36
OP42FP 36
Premium Fireplace Framing Dimensions -
If Installing Optional Drain Tray
Model A
OP36FP 37
OP42FP 37
33858-1-0615
Figure 13
A
C
B
(inches)
B
41 19-1/4
45 19-1/4
(inches)
B
41 19-1/4
45 19-1/4
Figure 14
Locating Fireplace
Place fireplace in framing opening. Use the tabs on the side of
the fireplace to attach fireplace to framing. Different tab locations
can be used for wall materials with a thickness of 1/2 inch or
5/8 inch. See Figure 15.
Framing tabs should fit directly against framing material. Use at
least one nail per bracket to secure in place.
Check squareness of the fireplace prior to securing to framed
opening. See Figure 16.
FRAMING TABS
3/8" GAP
REQUIRED
C
Extended Hoods
If the non-combustible facing material used to finish the fireplace
is over 1 inch thick, an extended hood that extends 2 inch farther
out into the room is recommended. Contract your Empire Dealer
for details.
VB4H36SS
C
VB4H42SS
NOTICE: Do not break knockouts in concrete liners. Gas inlet
connects to valve below firebox floor.
FRAMING HARDWARE
NOT INCLUDED
Figure 15
3/4" GAP
REQUIRED
CHECK TO SEE
THAT BOX IS SQUARE
PRIOR TO ATTACHING TO
FRAMING
FIREPLACE OPENING
Figure 16
Stainless Steel Extended Hood
Stainless Steel Extended Hood
3/8" GAP
REQUIRED
Page 15