Brinkmann ZONE Owner's Manual page 12

MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply.
Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and
corrected. See "Trouble Shooting" section of this manual.
Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner.
See "Burner Assembly/Maintenance" under Proper Care and Maintenance.
Note: Observe flame height on main and side burners when lit:
Flame should be a Blue/Yellow color between 1"–2" when burner
is on "HIGH."
TURNING OFF THE GRILL:
1. Turn off the cylinder valve.
2. Turn all burner control knobs to the "OFF" position.
Note: Turn off LP cylinder first to prevent gas
from being left in the system under pressure.
CAUTION:
• The cylinder valve should always be in the off,
or closed, position when the grill is not in use.
11
To turn off the cylinder valve,
turn knob clockwise until it stops.