Toyota Sienna 2016 User Manual page 66

66
1-1. For safe use
Installing child restraints using a seat belt (child restraint lock
function belt)
Rear facing Infant seat/convertible seat
■
Place the child restraint sys-
1
tem on the rear seat facing
the rear of the vehicle.
Run the seat belt through the
2
child restraint system and
insert the plate into the
buckle. Make sure that the
belt is not twisted.
Fully extend the shoulder belt
3
and allow it to retract to put it
in lock mode. In lock mode,
the belt cannot be extended.
While pushing
4
restraint system down into
the rear seat, allow the
shoulder belt to retract until
the child restraint system is
securely in place.
After the shoulder belt has
retracted to a point where there
is no slack in the belt, pull the
belt to check that it cannot be
extended.
SIENNA_OM_OM08013U_(U)
the child