Toyota Sienna 2016 User Manual page 588

588
8-2. Steps to take in an emergency
Connect the jumper cables according to the following procedures:
4
Connect a positive jumper cable clamp to the positive (+) battery
1
terminal on your vehicle
Connect the clamp on the other end of the positive cable to the
2
positive (+) battery terminal on the second vehicle
Connect a negative cable clamp to the negative (-) battery termi-
3
nal on the second vehicle
Connect the clamp at the other end of the negative cable to a
4
solid, stationary, unpainted metallic point away from the battery
and any moving parts, as shown in the illustration.
Start the engine of the second vehicle. Increase the engine speed
5
slightly and maintain at that level for approximately 5 minutes to
recharge the battery of your vehicle.
Vehicles with a smart key system only: Open and close any of the
6
doors of your vehicle with the engine switch off.
Maintain the engine speed of the second vehicle and start the
7
engine of your vehicle by turning the engine switch to the "ON"
position (vehicles without a smart key system) or turning the engine
switch to IGNITION ON mode (vehicles with a smart key system).
Once the vehicle's engine has started, remove the jumper cables in
8
the exact reverse order from which they were connected.
To install the engine cover, conduct the removal procedure in
9
reverse. After installing, check that the fixed pins are inserted
securely.
SIENNA_OM_OM08013U_(U)