Adjusting The Rear Shield; Mount The Counter Weights - Toro 03681 Operator's Manual

1. Cutting unit kickstand
3

Adjusting the Rear Shield

No Parts Required
Procedure
Under most conditions, best dispersion is attained
when the rear shield is closed (front discharge).
When conditions are heavy or wet, rear shield may
be opened.
To open the rear shield (Figure 4), loosen the cap screw
securing the shield to the left side plate, rotate the
shield to the open position and tighten the cap screw.
Figure 3
1. Rear shield
4

Mount the Counter Weights

No Parts Required
Procedure
All cutting units are shipped with the counter weight
mounted to the left end of the cutting unit. Use the
following diagram to determine the position of the
counter weights and reel motors.
1. On the #2 and #4 cutting units, remove the 2 cap
screws securing the counter weight to the left end
of the cutting unit. Remove the counter weight
(Figure 6).
5
Figure 4
2. Cap screw
Figure 5