Adjusting The Rear Shield; Mounting The Counterweights - Toro Reelmaster 3100-D Series Operator's Manual

1. Cutting-unit kickstand
3

Adjusting the Rear Shield

No Parts Required
Procedure
Under most conditions, the best dispersion is attained when
the rear shield is closed (front discharge). When conditions
are heavy or wet, the rear shield may be opened.
To open the rear shield (Figure
securing the shield to the left side plate, rotate the shield to
the open position and tighten the cap screw.
Figure 3
4), loosen the cap screw
1. Rear shield
4

Mounting the Counterweights

No Parts Required
Procedure
All cutting units are shipped with the counterweight mounted
to the left end of the cutting unit. Use the following diagram
to determine the position of the counterweights and reel
motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
1. On cutting unit 3, remove the 2 cap screws securing
the counterweight to the left end of the cutting unit,
and remove the counterweight
5
Figure 4
2. Cap screw
Figure 5
4. Reel motor
5. Weight
(Figure 6).