Servicing The Bedbar - Toro 03681 Operator's Manual

Note: Reel bearings do not require preload.
Over tightening reel bearing adjuster nut will
damage reel bearings.
4. Retighten set screw securing bearing adjusting nut
to bearing housing. Torque to 12-15 in-lb.

Servicing the Bedbar

Removing the Bedbar
1. Turn bedbar adjuster screws, counterclockwise, to
back bedknife away from reel (Figure 23).
1. Bedbar adjusting screw
2. Spring tension nut
2. Back out the spring tension nut, until the washer is
no longer tensioned against the bedbar (Figure 23).
3. On each side of the machine, loosen the lock nut
securing the bedbar bolt (Figure 24).
1. Bedbar bolt
4. Remove each bedbar bolt allowing bedbar to be
pulled downward and removed from machine bolt
(Figure 24). Account for 2 nylon and 1 stamped
steel washers on each end of bedbar (Figure 25).
Figure 23
3. Bedbar
4. Washer
Figure 24
2. Lock nut
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install bedbar, positioning mounting ears between
washer and bedbar adjuster.
2. Secure bedbar to each side plate with bedbar bolts
(nuts on bolts) and 6 washers. A nylon washer is to
be positioned on each side of side plate boss. Place
a steel washer outside each of the nylon washers
(Figure 25). Torque bedbar bolts to 27-33 ft.-lb.
Tighten locknuts until the outside steel washer
stops rotating and end play is removed but do not
overtighten or deflect side plates. Washers on
inside may have a gap.
3. Tighten spring tension nut until spring is collapsed,
then back off 1/2 turn (Figure 26).
1. Spring tension nut
16
Figure 25
3. Steel washer
4. Nylon washer
Figure 26
2. Spring