Download Print this page

Amana AKED3050 Owner's Manual page 5

Electric cartridge cooktop

Advertisement

Many different types of cartridges are available for the cooktop. By mixing
and matching different cartridges, your new cooktop is custom designed to
suit your individual needs.
CARTRIDGE TYPE
Smoothtop
Smoothtop
Coiltop
Coiltop
Grill
Griddle (accessory)
1. Turn all controls to OFF.
2. Verify surface of cooktop is cool to the touch.
3. Hold cartridge with terminals pointing toward rear of
cooktop.
• If cartridge pan from grill or griddle cartridge is in the
well, remove before installing the cartridge.
4. Place end of cartridge into cooktop well with terminals
facing rear of well.
• Lifting cartridge over 45° angle can cause damage
to cartridge terminals.
5. Slide cartridge towards rear of cooktop until cartridge
engages. Lower front of cartridge into well.
1. Turn all controls to off. Make sure surface is cool.
• Do not tilt cartridge too high.
• Lifting cartridge over 45° can cause damage to element terminals.
2. Using tab on front of cartridge, lift up slightly.
3. Pull cartridge toward the front of cooktop and carefully lift it out.
ELEMENT TYPE
Two radiant elements
Two radiant elements
Two coil elements
Two coil elements
Electric grill element
Electric grill element
PLACEMENT
Large element is in front and
cartridge can be installed
only on right side.
Large element is in back and
cartridge can be installed on
either side.
Cartridge with large element
in front can be installed only
on right side.
Large element is in back and
cartridge can be installed on
either side.
Can be installed right side,
left side or both.
Can be installed right side,
left side or both. Needs grill
cartridge.
!
WARNING
To avoid personal injury, do not
touch surface elements or area
near elements.
• Surface elements may be dark
in color even when hot.
• Areas near elements may be
hot enough to burn.
• Do not allow clothing or other
flammable materials to touch
cooktop during or after use.
!
WARNING
To avoid personal injury, all
controls must be in OFF position
before removing or installing
cartridges.
Terminal
opening

Advertisement

loading