Spare Parts; Disk Drive Removal; Table 2.1 Model And Parts Numbers - Fujitsu MHG2102AT Maintenance Manual

2.2 Disk Drive Removal

2.1 Spare Parts

See Table 2.1 for the model and parts numbers to order the replacement disk
drive.
Model
MHG2102AT
MHH2064AT
MHH2032AT
2.2 Disk Drive Removal
The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, is as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the
system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag.
To protect the device from damage and prevent the worker getting hurt, observe
the parts in Subsection 1.1.1 on Danger and Warnings.
1.
2.
3.
2-2

Table 2.1 Model and parts numbers

Part number Formatted
capacity
CA05310-B060 10.0 GB
CA05311-B040
CA05311-B020
Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
Do not move the drive until it comes to a complete stop (about
30 s after the power is turned OFF).
Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)
Removal and Replacement Procedure
Mounting screw
6.4 GB M3 (depth 3)
3.2 GB
C141-F034-01EN