Table of Contents
Advertisement
5.6
Fault Condition
A list of faults that may occur is given on
i
page 40.
In the unlikely event of a fault occuring while the appli-
ance is in operation:
The display then shows a fault code and the button
may also flash.
If the button
flashes:
B Press and hold the button
"– –".
The appliance will then start up again and the display
will show the central heating flow temperature.
If the button
does not flash:
B Switch the appliance off and then on again at the
master switch.
The appliance will start up again and the central heat-
ing flow temperature will be displayed.
6 720 611 137 GB (03.02)
until the display shows
Commissioning
25
Advertisement
Table of Contents
