Landing Skid Assembly - THUNDER TIGER Raptor 30 V2 Assembly & Maintenance Manual

7 Main Frame Assembly-Part3
Insert Main Shaft through the shaft bearings making sure that the end with the holes closest to the end is
pointed down. Next, slide main gear assembly into position on the shaft and line up the holes in the main
shaft with the holes in one way clutch shaft of the main gear assembly. Insert the socket head screw and
secure with the lock nut. Next, slide on the mainshaft lock ring on top of the main shaft bearing and secure
with the two set screws. Then slide on the swash plate assembly and attach the elevator and aileron
control linkages to the outside swash plate linkage balls. Next, slide on washout assembly and attach
washout linkage to the inner linkage balls of the swash plate.
(1) BK0616 Socket Screw(M3x20)............1
(2) HMM3Z Lock Nut (M3)........................ 1
(3) HME4-5B Set Screw (M4x5)............... 2
(4) BK0086 Ball Link ................................ 4
(5) BK0092 Linkage Rod ......................... 2
(6) BK0030 Main Shaft Lock Ring............ 1
(7) BK0029 Main Shaft ............................ 1
(8) Wash Out Assembly
(9) BV0601 Swash Plate Assembly...........1
(10) Main Gear Assembly
58mm

8 Landing Skid Assembly

(1) HSE3-18B Self Tapping Screw(M3x18).4
(2) HME4-5B Set Screw(M4x5)..................4
(3) BK0066 Skid Brace...............................2
(4) BK0064 Skid Pipe.................................2
(5) BK0065 Skid Pipe End Cap..................4
(4) BK0086
(5) BK0092
(4) BK0086
(6) BK0030
(10) Main Gear Assembly
(3) BK0066
(2) HME4-5B
(5) BK0065
(2) HMM3Z
(1) BK0616
(1) HSE3-18B
9
(7) BK0029
(8) Washout Assembly
(9) BV0601
(3) HME4-5B
(2) HME4-5B
(3) BK0066
(2) HME4-5B
(4) BK0064
(5) BK0065