Table of Contents
Advertisement
ADJUSTMENTS
VBS phase adjustment
1
Press the CURSOR (j or l) button to select the WRITE PROTECT function setting, then press the
CURSOR (d or c) button to select OFF, then press the SET button.
2
Connect a VBS signal source to the VBS IN connector on the camera.
The on-screen setting will automatically switch to VBS. Press the CURSOR (j or l) button to select the
on-screen VBS setting (get it flashing), then press the SET button. The adjustment sub-menu
"ADJUSTMENT FOR VBS" will be displayed.
3
Press the CURSOR (d or c) button to adjust the horizontal phase (H). The on-screen marker (b) will
move and the adjustment value will flash according to the horizontal phase setting.
When finished setting the horizontal phase (H), press the CURSOR (l) button to select the sub-carrier
(SC) phase.
4
Press the CURSOR (d or c) button to adjust the sub-carrier (SC) phase. The on-screen marker (b) will
move and the adjustment value will flash according to the sub-carrier phase setting.
Note: When an adjustment is made, the PRESET setting will automatically switch to OFF. To return to the
initial values, just return the PRESET setting to ON, then press the SET button.
5
When finished. (Refer to step 4 on page 16.)
Note: If using a VS sync signal, the H sync phase adjustment is made by following the same method as
described for the "VBS phase adjustment".
17
English
CURSOR
SET
MENU FOR ADJUSTMENT
SYNC
VBS
IRIS
AI
BLC
OFF
ADJUSTMENT FOR VBS
(PHASE)
H
o------z------p 280
SC
o------z------p 90
Advertisement
Table of Contents
