Fujitsu PRIMERGY BX600 S3 Service Supplement Manual page 13

Important notes
V
CAUTION!
Do not connect or disconnect any data transmission cables during a
thunderstorm (lightning hazard).
Be careful to ensure that no objects or liquids (e.g. jewelry, paper
clips, coffee etc.) get inside the device (electric shock, short circuit).
Data cables must be adequately shielded to avoid interference.
For the LAN wiring, the requirements according to standards
EN 50173 and EN 5017350174-1/2 apply. The minimum requirement
is the use of a protected LAN line of category 5 for 10/10050174Mbps
Ethernet, and/or of category 5e for Gigabit Ethernet. The require-
ments of the specification ISO/IEC 11801 must also be taken into
account.
In emergencies (e.g. damaged casing, control elements or cable,
penetration of liquids or foreign bodies), switch off the device immedi-
ately, unplug it from the grounded power outlet(s), and contact your
customer service center.
Proper operation of the device (in accordance with IEC 60950/DIN
EN 60950) is only ensured if the casing is completely assembled and
the installed dummy modules for the unused installation bays have
been put in place (electric shock, cooling, fire protection, interference
suppression).
Install only system extensions that satisfy the requirements and rules
governing safety, electromagnetic compatibility, and telecommunica-
tions terminal equipment. If you install other extensions, you might
damage the system or violate these safety regulations. Information
on which system extensions are suitable can be obtained from the
customer service center or your sales outlet.
The components marked with a warning label, e.g. lightning symbol,
should only be opened, removed or exchanged by authorized,
qualified personnel, with the exception of the hot-plug/hot-swap
components.
If you cause a defect on the device by installing or exchanging system
extensions, the warranty will be invalidated.
You should only set the resolutions and refresh rates specified in the
operating manual for your monitor. Otherwise, you may damage the
monitor. If you are in any doubt, contact your sales outlet or customer
service center.
Service Supplement
Notes on safety
13