Wipe Disk; Font Sharpening; Require Standby; Les Applications - Oki MB 780 Service Manual

Wipe Disk

This setting provides you with a tool for erasing the contents of a disk.
Wipe Disk removes a disk's data in such a way that it cannot be recovered.
Warning:
To change this setting:
• Select Wipe Disk from Configuration Menu.
Note: If an advanced password has been established, you must enter this password in
order to change the setting. If no advanced password exists, you can establish one by
using the keyboard that appears on the LCD.
• Select Wipe disk now. Contents will be lost. Continue? appears on the screen.
• Select "Yes" to continue, or touch "No" to exit.
• Select Back to return to Configuration Menu.

Font Sharpening

This setting allows a user to set a text point size below which the high frequency screens
are used when printing font data. For example, at the default 24, all text in font sizes 24
and less will use the high frequency screens. The values for this setting range from 0 to
150, and the default value is 24. This setting affects PostScript, PCL, and XL.
To change this setting:
• Select Font Sharpening from the Configuration Menu.
• Select ► to increase value or ◄ to decrease value.
•
Select "Submit" to save your change. Select "Back" to exit without changing.
This function is not supported when the device generates output at 600 dpi resolution.

Require Standby

This setting determines if the Standby Mode is "On" or "Off". The default is "On".
If Standby Mode is "On", the printer begins functioning in Standby Mode when it
remains idle for an amount of time. The Standby Mode enables the printer to consume
less energy than when operating in normal mode but not as little as when operating in
Power Saver and to return to the Ready state more quickly than when operating in Power
Saver.
To change this setting:
• Select Require Standby from the Configuration Menu.
• Select "Submit" to save your change. Select "Back" to exit without changing.

LES Applications

This disables all installed Local Embedded Solution applications. The default is Enabled.
To change this setting:
• Select LES Applications from the Configuration Menu.
Note: If an advanced password has been established, you must enter this password in
order to change the setting. If no advanced password exists, you can establish one by
using the keyboard that appears on the LCD.
• Select "Submit" to save your change. Select "Back" to exit without changing.
40