Pim-Sm Non-Scoped Zone Configuration Example - HP 5920 series Configuration Manual

Protocol: pim-dm, Flag: LOC ACT
UpTime: 00:03:27
Upstream interface: Vlan-interface300
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 2
1: Vlan-interface103
2: Vlan-interface102

PIM-SM non-scoped zone configuration example

Network requirements
As shown in
subnets form stub networks, and at least one receiver host exist in each stub network. The entire PIM-SM
domain contains only one BSR.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
Both VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs. The
C-BSR on Switch E has a higher priority. The C-RPs server the multicast group range 225.1.1.0/24. Modify
the hash mask length to map the multicast group range to the two C-RPs.
IGMPv2 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 33 Network diagram
Source
10.110.5.100/24
Device
Protocol: pim-dm, UpTime: 00:03:27, Expires: never
Protocol: pim-dm, UpTime: 00:03:27, Expires: never
Figure 33, VOD streams are sent to receiver hosts in multicast. The receivers of different
Vlan-int300 Vlan-int105
Vlan-int105
Switch D
PIM-SM
Interface IP address
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int104
Switch E
Vlan-int104
Vlan-int200
Switch C
Device
86
Receiver
Host A
Host B
Receiver
Vlan-int200
Switch B
Host C
Host D
Interface IP address