Ipv6 Pim-Sm Admin-Scoped Zone Configuration Example - HP 5920 series Configuration Manual

RP address
1003::2
4002::1

IPv6 PIM-SM admin-scoped zone configuration example

Network requirements
As shown in
domain is divided into IPv6 admin-scoped zone 1, IPv6 admin-scoped zone 2, and the IPv6
global-scoped zone. Switch B, Switch C, and Switch D are ZBRs of the three zones, respectively.
Source 1 and Source 2 send different IPv6 multicast data to the IPv6 multicast group FF14::101. Host A
receives the IPv6 multicast data only from Source 1, and Host B receives the IPv6 multicast data only from
Source 2. Source 3 sends IPv6 multicast data to the IPv6 multicast group FF1E::202. Host C is an IPv6
multicast receiver for the IPv6 multicast group FF1E::202.
VLAN-interface 101 of Switch B acts as a C-BSR and a C-RP for IPv6 admin-scoped zone 1, and
VLAN-interface 105 of Switch D acts as a C-BSR and a C-RP for IPv6 admin-scoped zone 2. Both of the
two interfaces serve the IPv6 multicast groups with the scope field value of 4. VLAN-interface 109 of
Switch F acts as a C-BSR and a C-RP for the IPv6 global-scoped zone, and it serves the IPv6 multicast
groups with the scope field value of 14.
MLDv1 runs between Switch A, Switch E, Switch I, and the receivers that directly connect to them,
respectively.
Figure 55 Network diagram
Device
Switch A
Figure 55, VOD streams are sent to receiver hosts in multicast. The entire IPv6 PIM-SM
Interface IPv6 address
Vlan-int100 1001::1/64
Priority HoldTime
192 180
192 180
Device
Switch D
165
Uptime Expires
00:05:19 00:02:11
00:05:19 00:02:11
Interface IPv6 address
Vlan-int105 3003::2/64