HP 5920 series Configuration Manual page 144

Ip multicast
Hide thumbs Also See for 5920 series:
Table of Contents

Advertisement

Graft
To reduce the join latency when a new receiver on a previously pruned branch joins an IPv6 multicast
group, IPv6 PIM-DM uses a graft mechanism to turn the pruned branch into a forwarding branch, as
follows:
The node that needs to receive the IPv6 multicast data sends a graft message to its upstream node,
1.
telling it to rejoin the SPT.
After receiving this graft message, the upstream node adds the interface that received the graft
2.
message into the outgoing interface list of the (S, G) entry for the IPv6 multicast group, and then
sends a graft-ack message to the graft sender.
If the node that sent a graft message does not receive a graft-ack message from its upstream node,
3.
it continues to send graft messages at a configurable interval until it receives an acknowledgment
from its upstream node.
Assert
On a subnet with more than one multicast router, the assert mechanism shuts off duplicate multicast flows
to the network. It does this by electing a unique multicast forwarder for the subnet.
Figure 46 Assert mechanism
As shown in
both forward the packet to the local subnet. As a result, the downstream node Router C receives two
identical multicast packets, and both Router A and Router B, on their own downstream interfaces, receive
a duplicate packet forwarded by the other. After detecting this condition, both routers send an assert
message to all IPv6 PIM routers on the local subnet through the interface that received the packet. The
assert message contains the IPv6 multicast source address (S), the IPv6 multicast group address (G), and
the preference and metric of the IPv6 unicast route to the IPv6 multicast source. By comparing these
parameters, either Router A or Router B becomes the unique forwarder of the subsequent (S, G) packets
on the subnet. The comparison process is as follows:
The router with a higher preference to the IPv6 multicast source wins.
1.
If both routers have the same preference to the IPv6 multicast source, the router with a smaller
2.
metric to the IPv6 multicast source wins.
If a tie exists in route metric to the IPv6 multicast source, the router with a higher IPv6 link-local
3.
address on the downstream interface wins.
Figure
46, after Router A and Router B receive an (S, G) packet from the upstream node, they
137

Advertisement

Table of Contents
loading

This manual is also suitable for:

5900 series

Table of Contents