Table of Contents
Advertisement
6. SPECIFICATIONS
GENERAL POWER AMPLIFIER SPECIFICATIONS
Power Output Per Channel
Low Z models, Stereo Mode, Both Channels Driven . . . . . . . . . . . . . . . . ne800
8Ω , 20Hz-20kHz 1%THD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 225W . . . . . . . . . .450W . . . . . . . . . 700W
4Ω , 20Hz-20kHz 1%THD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 400W . . . . . . . . . .800W . . . . . . . . .
Low Z models, Bridge Mode
8Ω , 20Hz-20kHz 1%THD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 800W . . . . . . . . . .1600W . . . . . . . . 2400W
Hi Z Distributed Output models, *25V,
20Hz-20kHz 1%THD, per channel . . . . . . . . . . . . . . . . . . . . . . . . . . . . 400W . . . . . . . . . .800W . . . . . . . . . 1200W
*25V Hi Z output is only available on ne800.
Line Current Draw (both channels driven 4Ω /Ch, 120VAC Mains)
Line Current, Standby mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200mA . . . . . . . . .165mA . . . . . . . . 200mA
Line Current, Idle (no signal) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 475mA . . . . . . . . .500mA . . . . . . . . 475mA
Line Current, Typical (1/8 power pink noise) . . . . . . . . . . . . . . . . . . . . 2.81A. . . . . . . . . .4.95A . . . . . . . . . 6.75A
Line Current, Maximum (1/3 power sine wave) . . . . . . . . . . . . . . . . . . 4.93A. . . . . . . . . .8.80A . . . . . . . . . 12.6A
Thermal Dissipation (BTU/hr, both channels driven 4Ω /Ch)
BTU/hr, Standby mode, . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 . . . . . . . . . . . .40 . . . . . . . . . . . . 40
BTU/hr, Idle (no signal) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 109 . . . . . . . . . . .109 . . . . . . . . . . . 109
BTU/hr, Typ (1/8 power pink noise) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 287 . . . . . . . . . . .447 . . . . . . . . . . . 682
BTU/hr, Max (1/3 power sine wave) . . . . . . . . . . . . . . . . . . . . . . . . . . . 297 . . . . . . . . . . .466 . . . . . . . . . . . 717
Signal to Noise (20Hz-20KHz, unweighted) . . . . . . . . . . . . . . . . . . . . . . >107dB . . . . . . . .>110dB. . . . . . . . >112dB
Distortion (SMPTE, typical) - 8 ohm load, 10dB below rated power: . . . . . . . . . . . . . . . . .<0.5%
Distortion (THD-N, typical) - 8 ohm load, 10dB below rated power, 20Hz-20kHz:. . . . . . .<0.5%
Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20Hz-20kHz, +/-1dB
Damping Factor (8 ohm load, <1kHz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>250
Input Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .20K Ohm, balanced
Input Sensitivity Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26dB, 32dB, 1.4V
Maximum Input Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .+21dBu
Amplifier Protection. . . . . inrush current limitation, temperature monitoring, output over-current protection, internal mains fuse
Cooling. . . . . . . . . . . . . . . temperature dependent speed-controlled fan, air in through sides and out through front
Control Network. . . . . . . . onboard, compatible with standard 100MB Ethernet hardware
Front Panel Indicators. . . Per Channel: Clip/Mute, -6dB, -12dB, -18dB, Temp, Current, Bridge
Overall: Power, Standby, Protect, Power Switch Disable, Com
Control Surface and Amp LEDs: Level meters are dB below RATED output
Attenuators: . . . . . . . . . . . Per channel: front panel, software, offset link group, and remote
Input Connections . . . . . . XLR Female /Euroblock
Analog Aux Outputs . . . . XLR Male / Euroblock
Output Connections . . . . . Speakon / Euroblock
Remote Standby . . . . . . . . Euroblock
Remote Level Control. . . . Euroblock
Compatible Ashly Remotes . . WR-1 DC Level Control
With Protea DSP Installed: neWR-5, FR-8/FR-16, and Ashly Remote iPad
Factory Options . . . . . . . . DSP processing (pe), AES3 digital audio (OPAES1), CobraNet or Dante network audio (CNM-2 or OPDante)
Power Cable Connector. . 15A Edison, 3-Prong IEC
Power Requirements . . . . 120VAC or 240VAC ±10%, 50/60Hz
Unit Dimensions. . . . . . . . 19"W x 3.5"H x 16.84"D (483 x 89 x 428mm)
Shipping Dimensions . . . . 24.5"W x 5.25"H x 22"D
Unit / Shipping Weight . . . <25.4 lbs (11.5kg) / <31.4 lbs (<14.2kg)
Environmental: . . . . . . . . 40-120 deg. F, (4-49 deg, C) noncondensing
Operating Manual - NE Two Channel Power Amplifiers
70V, and 100V
†
The Low Z ne2400 also doubles as Hi Z 70V model @1200W
†
ne1600
(.25, .70, .10)
(.70, .10)
ne2400
1200W
†
(.10)
app
®
11
Advertisement
Table of Contents
