Back Panel Model Xs748T; System And Port Leds Model Xs748T - NETGEAR XS728T Hardware Installation Manual

ProSAFE 28-Port and 48-Port 10-Gigabit Smart Managed Switch Models XS728T and XS748T

Back Panel Model XS748T

The following figure shows the back panel of model XS748T.
Figure 4. Back panel model XS748T
The back panel contains a Kensington™ lock slot and the AC power connector. The serial
console port is not for customer use.

System and Port LEDs Model XS748T

The following table describes the RJ-45 and SFP+ slot LED designations.
For each RJ-45 port, the left bicolor LED is for the top port and the right bicolor LED is for the
bottom port.
The LEDs for the SFP+ slots are located between the top and bottom SFP+ slots. Each SFP+
slot provides two single-color triangular LEDs. Triangular LEDs that point up are for slots 45
and 47; Triangular LEDs that point down are for slots 46 and 48.
Table 2. Port and system LEDs model XS748T
LED
Power
Fan
Speed/ACT LEDs for copper
ports 1 to 44
Kensington lock slot
Designation
• Solid green . The device is powered on.
• Solid yellow . The device is booting.
• Off . Power is not supplied to the device.
• Solid yellow . A fan failure occurred.
• Off . The fan is operating normally.
• Off. No link is established.
• Solid green. A valid 10 Gbps link is established.
• Blinking green. The port is transmitting or receiving packets at 10 Gbps.
• Solid yellow. A valid 1 Gbps link is established.
• Blinking yellow. The port is transmitting or receiving traffic at 1 Gbps.
Hardware Overview
14
AC power connector