NETGEAR XS728T Hardware Installation Manual page 9

ProSAFE 28-Port and 48-Port 10-Gigabit Smart Managed Switch Models XS728T and XS748T
• Operate the product only from the type of external power source indicated on the
electrical ratings label. If you are not sure of the type of power source required, consult
your service provider or local power company.
• To avoid damaging your system, be sure that the voltage selection switch (if provided) on
the power supply is set to match the power at your location.
The switch supports an input power rating of 100–240V, 50–60 Hz.
• Be sure that attached devices are electrically rated to operate with the power available in
your location.
• Use only approved power cables. If you were not provided with a power cable for your
system or for any AC-powered option intended for your system, purchase a power cable
approved for your country. The power cable must be rated for the product and for the
voltage and current marked on the product electrical ratings label. The voltage and
current rating of the cable must be greater than the ratings marked on the product.
• To help prevent electric shock, plug the system and peripheral power cables into properly
grounded electrical outlets.
• The peripheral power cables are equipped with three-prong plugs to help ensure proper
grounding. Do not use adapter plugs or remove the grounding prong from a cable. If you
must use an extension cable, use a three-wire cable with properly grounded plugs.
• Observe extension cable and power strip ratings. Make sure that the total ampere rating
of all products plugged into the extension cable or power strip does not exceed 80
percent of the ampere ratings limit for the extension cable or power strip.
• To help protect your system from sudden, transient increases and decreases in electrical
power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).
• Position system cables and power cables carefully. Route cables so that they cannot be
stepped on or tripped over. Be sure that nothing rests on any cables.
• Do not modify power cables or plugs. Consult a licensed electrician or your power
company for site modifications.
• Always follow your local and national wiring rules.
Introduction
9