Guide Bar - Makita UC3020A Instruction Manual

2
1. Press in.
2. Loosen
1
2
3
1. Low
2. High
3. Adjusting dial

4. Guide bar

5. Saw chain
2
1. Press in
2. Tighten
Press in the lever. With the lever depressed, make a quarter turn on it counter-
006934
clockwise to loosen the nut lightly. (Pressing in the lever leads to the fitting of
1
lever into the nut.)
Turn the adjusting dial to adjust saw chain tension. Grasp the saw chain in the
006935
middle of the guide bar and lift up. The gap between the guide bar and the tie
2-4mm
strap of the saw chain should be approx. 2 - 4 mm. If the gap is not approx. 2 -
4 mm, slightly turn the adjusting dial which secures the guide bar. At this time,
adjust with the tip of guide bar slightly pointing up.
5
4
With the lever depressed, turn it fully clockwise to tighten the nut firmly.
006936
1
Return the lever to its original position.
006937
CAUTION:
• Excessively high tension of saw chain may cause breakage of saw chain,
wear of the guide bar and breakage of the adjusting dial.
• Installing or removing saw chain should be carried out in a clean place
free from sawdust and the like.
11