Konica Minolta magicolor 2590MF User Manual page 194

Symptom
Printing
takes too
much time.
Blank pages
are printed.
Not all pages
print.
Some parts
of the image
are lost with
2in1 copying.
180
Downloaded From ManualsPrinter.com Manuals
Cause
The machine is set to
a slow printing mode
(for example, thick
stock or transpar-
ency).
The machine is set to
power saving mode.
The job is very com-
plex.
A toner cartridge for a
different region or an
unapproved toner
cartridge is installed
(
X TONER INCOR-
is displayed in
RECT
the message win-
dow).
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
The Cancel key was
pressed.
The tray is empty.
A document is printed
with an overlay file
which has been cre-
ated by a magicolor
2590MF printer
driver.
If the Media type is
Envelope and the
zoom ratio for 2in1
copying will be less
than 50%, the zoom
ratio is set to 50%.
Solution
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode.
Wait. No action needed.
Install a correct KONICA MINOLTA
toner cartridge approved for your spe-
cific machine.
Check the toner cartridges. The image
will not print correctly or not at all, if the
cartridges are empty.
Check that the media type.
Make sure no one pressed the Cancel
key while your job was printing.
Check that the tray is loaded with
media, in place, and secure.
Print the overlay file using a magicolor
2590MF printer driver.
Press the + or , key to adjust the
zoom ratio.
Solving Other Problems