Rear Terminal
①
R/C jACK
When using the wired remote control, connect
the wired remote control to this jack with a remote
control cable (not supplied).
②
USB
In order to operate the computer with the remote
control and use the PAGE
remote control during a presentation, connect the
USB port of the computer to the USB terminal with
a USB cable (not supplied) (pp.13, 19).
③
SERVICE PORT
This jack is used to service the projector.
④
COMPUTER IN /COMPONENT IN
Connect the computer or component video (or RGB
Scart) output signal to this terminal (pp.19, 21).
Use the supplied VGA cable or a Component-VGA
cable commercially available.
⑤
MONITOR OUT
This terminal can be used to output the incoming
RGB analog signal from COMPUTER IN 1 and
COMPUTER IN 2/COMPONENT IN terminal to the
other monitor (p.19).
⑥
COMPUTER IN 1/DVI-I
Connect computer output (Digital/Analog DVI-I
type) to this terminal (p.19).
⑦
LAN Connection Terminal
Connect the LAN cable (Refer to the owner's
manual of "Network Set-up and Operation".).
Downloaded From projector-manual.com Sanyo Manuals
①
②
③
buttons on the
▲▼
④
⑤
⑧
⑨
⑩
⑧
VIDEO IN
Connect the composite video output signal to this
jack (p.20).
⑨
AUDIO IN
Connect the audio output signal from video
equipment connected to
mono audio signal (a single audio jack), connect it
to the L (MONO) jack (p.20).
⑩
COMPUTER/COMPONENT AUDIO IN
Connect the audio output (stereo) signal from a
computer or video equipment connected to
to this jack (pp.19, 21).
⑪
AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.19–21).
This terminal outputs sound from AUDIO IN terminal
or
).
⑨
⑩
(
⑫
S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.20).
⑬
SD Card Indicator
Display the status of SD card.When inserting SD
Card, the indicator lights, and when removing SD
Card, the indicator turns off.
⑭
SD Card Slot
Insert the SD card memory (not supplied) for
Memory viewer operation.
Part Names and Functions
⑥
⑦
SD
⑪
⑫
⑬
⑭
or
to this jack. For a
⑧
⑫
or
④
⑥
11