Basic Operation; Turning On The Projector - Sanyo PLC-XU115 Owner's Manual

Basic Operation

Turning On the Projector

Complete peripheral connections (with a computer,
1
VCR, etc.) before turning on the projector.
Connect the projector's AC power cord into an AC

outlet. The POWER indicator lights red. Open the lens
cap (see pages 10,60).
Press the POWER ON/SYAND-BY button on the top

control or on the remote control. The POWER indicator
lights green and the cooling fans start to operate. The
preparation display appears on the screen and the
count down starts.
After the countdown, the input source that was selected

the last time and the lamp control status icon (see page
53) appear on the screen.
If the projector is locked with a PIN code, PIN code
input dialog box will appear. Enter the PIN code as
instructed below.
Enter a PIN code
Use the Point
Point button to fix the number and move the red frame
►
pointer to the next box. The number changes to "." If you
fixed an incorrect number, use the Point
the pointer to the number you want to correct, and then
enter the correct number.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to
"Set." Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect PIN code, "PIN code" and the
number () will turn red for a moment. Enter the
correct PIN code all over again.
what is PIN code?
PIN (Personal Identification Number) code is a security
code that allows the person who knows it to operate the
projector. Setting a PIN code prevents unauthorized use of
the projector.
A PIN code consists of a four-digit number. Refer to the PIN
code lock function in the Setting Menu on pages 54–55 for
locking operation of the projector with your PIN code.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Take a special care in setting
a new PIN code; write down the number in a
column on page 76 of this manual and keep it
at hand. Should the PIN code be missing or
forgotten, consult your dealer or service center.

Downloaded From projector-manual.com Sanyo Manuals
buttons to enter a number. Press the
▲▼
The preparation display will disappear
after 30 seconds.
Selected Input Source and Lamp Control
(See page 53 for Lamp control status.)
PIN Code Input Dialog Box
button to move
◄
16
Lamp control status

Note:
• The Filter warning and Lamp replacement
icons may appear on the screen depending
on the usage state of the projector.
After the OK icon disappears,
you can operate the projector.

Notes:
• When the Logo select function is set to
"Off," the logo will not be shown on the
screen (p.50).
• When the "Countdown off" or "Off" is
selected in the Display function, the
countdown will not be shown on the screen
(p.48).
• During the countdown period, all operations
are invalid.
• If the correct PIN code number is not
entered within three minutes after the PIN
code dialog box appeared, the projector will
be turned off automatically.
• The "1234" is set as the initial PIN code at
the factory.
• When the Input Search function is set to
"On2", the input signal will be searched
automatically (p.51)