Part Names And Functions; Rear Terminal - Sanyo PLV-Z3000 Owner's Manual

Rear Terminal

HDMI 1
t
q COMPUTER
Connect the computer output signal, or RGB Scart 21-
pin video output to this connector (p.17).
w S-VIDEO
Connect the S-Video output signal from video equipment
to this jack (p.16).
e COMPONENT 1 or COMPONENT 2
Connect the component video output signal to these
jacks (p.16).
q w
S-VIDEO
HDMI 2 COMPUTER
VIDEO
y

Part Names and Functions

e
COMPONENT 1
COMPONENT 2
Y Pb/Cb Pr/Cr
r SERVICE PORT
This jack is used to service the projector.
t HDMI 1/HDMI 2*
Connect the HDMI output signal from video equipment
to these terminals (p.16).
y VIDEO
Connect the composite video output signal from video
equipment to this jack (p.16).
* Note on the HDMI connector:
Use the HDMI connector less than the size shown below.
Otherwise you cannot connect use HDMI 1 and HDMI 2
terminals at the same time.
Maximum dimensions of the HDMI connectors
0.94" (24 mm)
WIDTH
r
SERVICEPORT
0.59" (15 mm)
THICKNESS
9