Configuring the HP AdvanceStack Internet Router
Configuring ISDN
12. Enter the dialer list command to specify the groups and protocols
13. Configure a static route to allow connection to the target router's LAN.
14. Enter the exit command to exit global configuration mode.
15. Enter the copy running-config startup-config command to save the
Example ISDN Configuration
For your reference, table 3-3 shows an example configuration for two Cisco
routers using IP over ISDN. In the example, the current router (branch1) is at
a remote site and the target router (main1) is at a central site.
3-18
permitted to access the router:
Router (config)# dialer-list groupnumber protocol protocol_type
permit
Enter the IP address and subnet mask of the target router's LAN interface,
and the IP address of the target router's BRI port:
Router (config)# ip route targetrouter_ipnetwork subnetmask
targetBRIport_ipaddress
configuration to NVRAM.