Setting Unit For Termination - Honeywell ScanDome II HSDN-251NS/PS Operation & Programming Manual

The dome camera must be installed by qualified service personnel in accordance with all local
and federal electrical and building codes. The system should be installed according to Figures 2
through 8.
Address(ID) selection
Switches
S3 S6
S2 S5
S1 S4

2.3 Setting Unit for Termination

The device which is connected at end of line, whether it be a dome camera or keyboard
controller, must have the cable for communication terminated by setting the appropriate DIP
switch. Without proper termination, there is potential for control signal errors. Total length of the
cable for communication should not exceed 1.2Km.
SW1
ON
KSD02H
1 2
9A
Termination Switches
SW1
O N
KS D02H
1 2
9A
Protocol selection
Switches
Figure 4• Layout of Switches
SW1
Terminated
Not terminated
Figure 5• Setting Unit for Termination
1
ON
OFF
5
2
ON
OFF