Honeywell ScanDome II HSDN-251NS/PS Operation & Programming Manual page 31

When the dome camera is installed near wall, panning range could be programmed by user.
㿱FLIP
Allows the dome camera to automatically turn 180 degrees when the camera tilts to its lower
position.
When camera reaches floor alone moving object, it will stop. Release the Joystick handle
instantly and then pull down to run flip function. The speed of following object will be same
speed as previous.
㿱TILT Over Angle
This option is used to set the limit of the horizontal view angle so that the trim ring or ceiling does
not obstruct the horizontal image when zooming out (wide angle).
ON: In some installations it is desirable for the dome camera to be able to see the above
horizon. When this option is chosen, the dome will tilt up over the horizon(About 10 degree ).
When the lens is zoomed out, you can see the ceiling line. But when the lens is zoomed in
the viewing angle is narrower, and the ceiling line disappears.
Without Bubble: The tilt range of the camera is limited to see the horizon so the picture
shows part of the ceiling line.
With Bubble: The tilt range of the camera is limited to see below the horizon (- 10 degrees).
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin Offset
of tilt angle as described below.
㿱INITIALIZE DATA
Erase all stored data from the Flash-ROM of the selected dome camera. You will be asked to
enter Yes or No. If you intend to erase all data then press the Menu key, otherwise press the
ESC key to exit without erasing. The erased data includes all stored data ( titles, presets, and
tours" .) except origin offset.
PANNING RANGE MENU
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP RIGHT/LEFT
SAVE AND EXIT(ESC TO CANCEL)
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
EXIT(ESC TO EXIT)
25