Advanced Setup; Advanced Speaker Settings; Crossover Frequency - Onkyo TX-SR573 Instruction Manual

Advanced Setup

Advanced Speaker Settings

The advanced speaker settings cannot be
changed while headphones are connected,
speaker set B is on, or the multichannel DVD
input is selected.

Crossover Frequency

To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your subwoofer
and other speakers.
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
RECEIVER
[SETUP] button.
2
Use the Up and Down [
buttons to select "1. Speaker
Config," and then press the
ENTER
[ENTER] button.
ENTER
3
Use the Down [
select "Crossover," and then use
ENTER
the Left and Right [
tons to select a crossover fre-
quency.
Choose a crossover frequency suitable
for your setup.
If you're using a subwoofer, choose a
ENTER
crossover frequency based on the diam-
eter of your front speakers.
If you're not using a subwoofer, use
the diameter of the first speaker that
you specified as Small in steps 4
through 7 of the Speaker Configuration
on page 32.
Note:
• For a more accurate setting, look up the frequency
]/[ ]
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can only be set
if in the Speaker Configuration on page 32, the Sub-
woofer setting is set to Yes (step 3), and the Front setting
is set to Large (step 4).
] button to
]/[ ] but-
Speaker cone
diameter
Over 8 in.
(20 cm)
6-1/2 to 8 in.
(16–20 cm)
5-1/4 to 6-1/2 in.
(13–16 cm)
3-1/2 to 5-1/4 in.
(9–13 cm)
Under 3-1/2 in.
(9 cm)
Continue with step 4, "Double Bass."
response in the manuals supplied with your speakers
and set accordingly. In addition, listen to some music
that you know well and choose a higher crossover fre-
quency if you think there's not enough sound coming
from the subwoofer; a lower setting if you think
there's too much.
4
Use the Down [
select "Double Bass," and then
ENTER
use the Left and Right [
buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
ENTER
Off: Double Bass function off.
5 Press the [SETUP] button.
Setup closes.
Crossover
frequency
60Hz
80Hz
100Hz (default)
120Hz
150Hz
] button to
]/[ ]
51