Listening To The Radio; Am Frequency Step Setup (On Some Models) - Onkyo TX-SR506 Instruction Manual

Listening to the Radio

AM Frequency Step Setup
(on some models)
2, 3
1, 5
For AM tuning to work properly, you must specify the
AM frequency step used in your area. Note that when
this setting is changed, all radio presets are deleted.
To change the frequency step on the TX-SR576,
see page 74.
To change the frequency step on the TX-SR506,
follow the procedure below.
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
1
2–4
3
4
5
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Use the Up and Down [
buttons to select "0.Hardware-
Setup," and then press [ENTER].
Use the Up and Down [
buttons to select "AM Freq."
Use the Left and Right [
buttons to select:
10kHz: Select if 10kHz steps are used
in your area.
9kHz: Select if 9kHz steps are used
in your area.
Press the [SETUP] button.
Setup closes.
]/[ ]
]/[ ]
]/[ ]
49